LED Dimmable Driver – Seek Advice..

If you are intending on installing LED strip lights (also called LED tape) you should be able to accurately calculate the power required. Having insufficient power supply will result in only some (or none) of the LEDs illuminating, or may cause irritation flicker. An over specified power source will surely cost more to buy, and will also be harder to fit as they are bigger.

To calculate the energy supply necessary for your LED driver, you should know: Length of the strip or tape, Variety of LEDs per metre, Power consumption per LED. To calculate the dimensions of power supply (in Amps) you need to multiply the duration of the LED tape by the amount of the LEDs per metre then multiply this by the strength of the LED (.08w to .24w per LED are typical values). Then divide the worth by 12 volts to calculate the desired Amperage of the power supply.

(Duration of LED Strip x LEDs per Metre x LED Power) / 12 We recommend you add at the very least 10% towards the calculated value to enable for resistance and losses inside the cables. You will also have to enable any possible expansions or additions in the future. Most LED Strip Lights may have additional sections added using joining cables.

Calculation Examples: Example 1: A 5m roll of SMD3528 (.08w) with 60LED/m could be: (5m x 60 x .08) / 12 = 2amps 10% = 2.2Amps. Example 2: A 5m roll of SMD5050 with 60LED/m could be: (5m x 60 x .24) / 12 = 6amps 10% = 6.6Amps.

For any LED strips over 2 metres long it is possible to offer a 12volt feed to both ends of the strip or one feed at the center, by cutting the strip into two and connecting the energy supply to both strips. This provides a much more even power distribution and must offer a more consistent illumination.

LED Strip Light Uses – There are two premiere factors behind using LED strips. The initial one is efficiency – LEDA driver 12v are extremely efficient, with the majority of the power planning to produce light, not heat. Their extremely extended life (20,000 hours is typical) means that additionally they do not need replaced very often, leading to vastly reduced lifetime costs.

One other reason is aesthetic. Leds can be produced extremely small – some LED lighting strips are as thin as 4mm – and so can be set up in places where traditional lights would not fit. Enhance this the different LED colour options, including RGB LEDs with remote controlled colour changing abilities. This gives a new selection of possible lighting effects that can dramatically change the style of an area.

Unlike other traditional lights which require bundles of cables and drain plenty of power, LED lights tend to be easier to use and simple to set up. The cluster of such miniature size lights are fixtures made in such hapmys efficient way that they are competent at illuminating any area of your choice. Installing LED lights in your commercial or residential application will help keep environment green, save your energy cost and most importantly, makes you a wise owner who follows most advanced technology trends.

Every lighting technology has some attributes that determines its nature and requirements of installation. Similar is the case with LED, you should think, decide and plan precisely to have LED dimmable driver properly installed in your place. LEDs uses are versatile and thus its type and specifications are also varied in accordance towards the application. LEDs are applicable in both dry and wet areas, learning the proper fixture available for each will certainly make your installation process easier.